1:1 Lancia RDA clone quick review

Lancia RDA from Angelcigs

10730973_810593269002989_7822769621783511583_n

This RDA was way better than I expected. Out of the box, it was machined real nice. Negative post are milled into the deck itself, so spinning post, is not going to be a problem. Im using the glass section and it”s a great fit, no leaks from orings. 3 different choices for air flow, with the supplied pins. Im using the biggest air flow pins. I read some feed back about pins falling out, but mine are secure, and I have my cotton resting over them. I’ve held it upside down and shaken as hard as I can, they don’t move, even after getting it super hot from chain vaping. Not sure if it is the way I have my cotton resting on top that makes then not fall out, but they don’t. Did a 6 wrap 26ga dual coil build. It’s been chain vaped for 2 days solid, (30 ml of juice) and no problems, best flavor RDA I have. Used it on Cana mods, ZNA50, Mechanical box mod, and Nemisis, connected to them all and fired. Would recommend this RDA if you love flavor and good clouds. Be careful not to over fill or it will leak out of air pins. (Happened to me once :() Very happy with this RDA!

532910_810594859002830_2765229138135170520_n

1459172_810593405669642_5553926378349285037_n

This review is written by Angelcigs loyal customer Jim Xmark.

3 thoughts on “1:1 Lancia RDA clone quick review

  1. I inserted the plugs with a peace of 32 gauge Kanthal wire in the hole and that held them in well. I heard there was a problem with the original Lancia were the plugs get too tight and are hard to get out.

    Like

    1. Yes, it’s the original design defect. This RDA does provide best flavor just hope this defect would be fixed in next version.

      Like

Leave a comment